Injection moulded cups fabricated from polypropylene and

Shakir AZIM, PhD Scholar in Ghent University Belgium, Master of Science, University of Engineering and Technology, Peshawar, Peshawar, Department of Industrial Engineering

Desirability and overlay contour plot showing optimum method operable

Injection moulded cups fabricated from polypropylene and polystyrene.

Muhammad ABAS, Lecturer, PhD Industrial Engineering, University of Engineering and Technology, Peshawar, Peshawar, Department of Industrial Engineering

Schematic of possible shrinkages in injection moulding.

Shakir AZIM, PhD Scholar in Ghent University Belgium, Master of Science, University of Engineering and Technology, Peshawar, Peshawar, Department of Industrial Engineering

Installation of mould and cup fabrication in a horizontal injection

Muhammad ABAS, Lecturer, PhD Industrial Engineering, University of Engineering and Technology, Peshawar, Peshawar, Department of Industrial Engineering

Injection moulded cups fabricated from polypropylene and polystyrene.

a) Surface plots of modeled parameters for shrinkage in cross-flow

3D surface and 2D Contour plots depicting the effect of (A and B)