The main scope of this question is about hobby 3D printer. The element in scope are 10K NTC thermistor for temperature sensor Stepper motor NEMA17 required about 1.0 A Hotend heater 12V 40W required
noise - Placement of signal, power and ground lines within a
Cable Connectors: FFC, FPC, & Ribbon
Ribbon Cables - Wiringo
Why is copper wire rated at higher amps in higher temperatures
Tinned Copper Wire vs. Bare Copper Wire: When Is It Best to Use Each O
I got these yesterday. : r/audiophile
50106HFP - Industrial Ethernet Cable
Make Noise DXG Dual Stereo Low Pass Gate and Mixer Module
Why isn't this ribbon cable between two board-to-board connectors
Basics of terminal blocks and their various subtypes
Altium's Revolutionary Harness Design Feature Unveiled
Dont Go Tripping Over Flat Ethernet Cables
PVC Shielded Flat Ribbon Cable
signal - Why is one return conductor for each forward conductor in
Cognex CCB-PWRIO-10 CABLE, M12,12 PIN POWER AND I/O BREAKOUT CABLE